Advanced Search

COMPETITION CRANK SUPER DAMPER

The best damper available. These will stand much higher revs and absorb the harmonics from the engine. Ideal to make a fast road car smoother and a MUST for race and rally cars.

STEEL CRANKSHAFT-MGC

Made from EN40B and Nitride hardened, these are for the serious competitor who is looking for the ultimate performance and reliability from their engine. Having the original stroke and using std. main & big-end bearings. It can be used with standard or our Steel Con Rod Set MCENG632R, the flywheel fixing is 12 bolt which will line up to the standard flywheel and rear seal.

COMPETITION CRANK SUPER DAMPER

The best damper available. These will stand much higher revs and absorb the harmonics from the engine. Ideal to make a fast road car smoother and a MUST for race and rally cars.

Choice of two pulleys - Road with original diameter fan belt vee pulley and Race with smaller diameter belt to allow for higher RPM.

STEEL CON ROD SET

These H-Beam style English made con rods are considerably lighter and stronger than standard ones, using far better and stronger rod bolts. A direct replacement for standard or fits with our steel crank.

FORGED PISTONS

These pistons are manufactured exclusively for us by both Omega. They are designed for competition and therefore are much stronger but are equally good for road use. They are a direct replacement for the originals and require no special liners, head gaskets, etc. To keep the compression ratio as high as possible they are machined in height to the upper-most limit and this means, if the engine block has been skimmed at any time, the piston top may have to be machined to suit. This is standard practice with all good engine builders and therefore should not pose any problem. These pistons come in sets of six, including gudgeon pins, circlips and rings.

Please note: The sizes quoted are finished bore sizes and all tolerances have been allowed for on the piston. We have used metric sizes in order to take advantage of the latest piston ring technology. Replacement rings available, please state diameter and width when ordering.

ALUMINIUM FLYWHEELS

These are CNC machined from a solid aluminium billet with a ground steel friction ring attached to provide the clutch face. The thin ring gear is fitted and grub screwed. Made in our own factory to our design. These weigh only 4.6 Kg (10.1lb) complete. So are very suitable for serious fast road and rally cars which wish to use the 7.25" Clutch

ALUMINIUM FLYWHEELS

These are CNC machined from a solid aluminium billet with a ground steel friction ring attached to provide the clutch face. The thin ring gear is fitted and grub screwed. Made in our own factory to our design. These weigh only 4.6 Kg (10.1lb) complete. So are very suitable for serious fast road and rally cars which wish to use the 9 1/2" clutch.

STEEL FLYWHEELS

These are machined from a solid billet to suit either a 7.25" twin plate race clutch or the 9 1/2" organic clutch, To suit the orginal 6 bolt or our 12 bolt steel crank fixing. All have considerable lightening holes where possible, the ones to suit the race clutch also only accept a thin ring gear. 6 or 12 Bolt, Organic 6 or 12 Bolt, Race - Made to order.

HEAVY DUTY FLYWHEEL BOLT

12 point head, excellent quality, a direct replacement for standard.

LIGHTWEIGHT STARTER RING GEAR

We have had this specially made, so that the flywheel can be lightened even more. 0.375" thick and weighing only 1.1 kgs, they have a 40% weight saving.

Only recommended with our pre-engaged starter.