Advanced Search

TWIN CARB INLET MANIFOLDS

Reproduction of the originals, made from our pattern equiptment and CNC machined to our drawings these are available as standard or gas flowed with polished ports for increased performance, also machined to clear our tubular exhaust manifold if required, at an extra cost of £45.00.

Please advise with order if this modification is required.

TRIPLE S.U. INLET MANIFOLDS

These manifolds will accept either 1.75" or can be opened out to suit 2" S.U. carbs.

They come complete with stainless steel balance pipe and bracket for throttle operating rod.

UPSWEPT WEBER INLET MANIFOLDS

Cast in aluminium, these manifolds are similar to the Works type, although running at approx 16 degrees and a little shorter, allows them to be used for left or right hand drive and gives a little extra power.

They are designed not to need the support towers.

PLEASE NOTE: Modified pedal box (CBRK300W) should be used for LHD.

BJ8 CARBURETTORS

New pair of 2" HD8 S.U's. As standard fitment to the BJ8.

THROTTLE CABLE CONVERSION

Convert any 6 cylinder with the BJ8 twin SU carb mechanical linkage arrangement, to the smooth reliable operation of twin cables using a similar design to our Weber kit.

Supplied complete except the outer cable bracket at the pedal end (which must be fabricated yourself).

Suits LH & RH drive. 

Not compatible with the original overdrive throttle kick down relay.

WEBER 45 DCOE CARBURETTOR

These come jetted approximately for the 3000. We also carry a full range of jets & chokes etc. Available separately.

TRIPLE WEBER AIR FILTERS

High flow design, foam construction to make the most of the space constraints.

TRIPLE WEBER THROTTLE LINKAGE KIT

This converts the car to twin throttle cables which is based on the Works design but with our improvements.

It is complete except for the outer cable bracket at the pedal end (which must be fabricated yourself).

Suits LH & RH drive, upswept manifolds only.

WEBER HEAT SHIELD KIT

Aluminium plate with insulation spacer and screws to fit to the bottom of any side draft Weber carb. May require trimming around exhausts.

PLEASE NOTE: 1 kit required per carburettor.

WEBER CARB INSULATION SPACER

1/4" thick Weber Carb Spacer. Insulate the weber from the manifold heat, two required per carb and four gaskets.