Advanced Search

ALUMINIUM RADIATORS

These are the latest design and are available on an outright purchase.

UP-RATED RADIATORS

These radiators have been specially developed from our competition experiences. They are fitted with a special core which has more cooling tubes and fins per square inch. This helps keep the running temperatures down.

Silicone Hose Sets

Black period looking with heater pipes. Sets or top and bottom hoses individually.

4 CYLINDER NARROW FAN BELT CONVERSION KIT

Designed to eliminate the vibration problems at high revs caused by the original wide fan belt.

This kit consists of an aluminium deep 'V' water pump pulley, aluminium deep 'V' dynamo pulley, cast iron crankshaft pulley and cogged fan belt to suit.

This kit is to suit the original dynamo, the pulleys are available separately if using an alternator.

ALUMINIUM WATER PUMP PULLEY

Designed with a much deeper "V" for the belt to run in. This helps to stop the belt from jumping off when high revs are being used.

ELECTRIC FAN KITS

Our electric fan kits are available for both Negative and Positive Earth vehicles and attach directly to the radiator core using the supplied tie kit. An in-hose thermostatic controller is used to more accuraetly control when the fan switches on and off.

Kit comprises of fan, tie mount kit. in-hose thermostatic controller, relay, wires and fuses required for installation.

Two sizes are available: 10" suits a 100 and a 3000 with our oil cooler kit and the 12" suits a 3000 with no oil cooler. 

PLASTIC FIVE BLADE FANS

Being of a modern design, these are very efficient in cooling and will stand higher revs without fear of breaking and flying apart causing serious damage.

The asymmetric design makes these considerably quieter than the steel six blade.

OIL COOLER KITS

Both our kits use 5/8 BSP fittings with large bore stainless steel braided hose to increase oil flow. Included is a 13 row 5/8 BSP cooler with specific brackets.

The 6 cylinder cooler bolts directly to the front lower part of the radiator using the radiators own mounting bolts.

The 4 cylinder brackets give the choice of mounting it vertically in front of the radiator attached to the ducting or horizontally to the ducting with a hole cut and small scoop. In each case the pipes are the correct length to match with the filter sandwich plate. This kit must be fitted with a spin-on filter kit purchased separately.

REMOTE OIL FILTER ADAPTORS

These adaptors are for people that wish to fit a remote oil filter as per the works cars. They bolt directly onto the side of the block and have two BSP threads to accept the oil pipes unions. Gasket and bolts included.

REMOTE OIL FILTER HOUSINGS

These housings can be bolted to the foot well or inner wing and accepts a modern spin-on type filter, they are also available with or without a 5/8" UNF thread for a temperature sender.